HOME > PRODUCTS > AIR ACCESSORIES

Air Accessories

This Air Locker Installation kit provides a simple method for actuating your air locker using any 12-volt or engine compressor with a tank.

Lockers can be engaged from the dash using a single mechanical toggle switch.
Eliminates the need for a solenoid valve and electrical switch.
Only one moving part means less chance of failure.
Includes installation instructions and everything needed for one locker.
Part # AL001

(Back to Top)

This Air Line Repair Kit is a must for vehicles that utilize air locking differentials.
This convenient kit has all of the needed parts to repair a damaged air line and get you back out on the trail in minutes.

Part# RK001

(Back to Top)

150 psi rated tank is ideal for air locker setups or running small air tools. Measuring 6" x 24", this tank can be easily mounted alongside or between frame rails. Five 1/4" NPT openings allow mounting in any position.

Part # PA501

(Back to Top)

Complete kit includes everything needed to install an air tank (Part # PA501) in your vehicle (tank sold separately).

QuickAir1	QuickAir2	QuickAir3
Kit # PA502	Kit # PA502B	Kit # PA502C

1 1/2" gauge, mounting panel, air line & Fittings
Pressure switch
Drain Valve
Quick-Disconnect Coupler
1/4" NPT Plug
QuickAIR2 kit includes 40A relay

(Back to Top)

These Pressure switches are for use with closed systems. The pressure switch will turn the compressor on and off at the predetermined pressures, depending on which compressor you are using.

QuickAir1	QuickAir2	QuickAir3
Part # PS001 80 PSI ON 115 PSI OFF 1/8" NPT	Part # PS002 80 PSI ON 105 PSI OFF 1/4" NPT	Part # PS003 55 PSI ON 70 PSI OFF 1/4" NPT

(Back to Top)

We carry two different styles of tire chucks. Both styles are clip-on type, and are available as open or closed. The Standard Ball Chuck is included on our coil hoses (Part No. PA505) The European Style chucks provide a better seal and more positive attachment to the valve stem (Coiled Air Hose, closed chuck - Part No. PA505C).

If you are running a compressor without a pressure switch, you should always use an open chuck to protect the compressor from overload and excess pressure buildup.

Part No. PA526 ・Open Chuck / Standard Ball
Part No. CH360-OP ・Open Chuck / European Style

If your compressor system uses a pressure switch to automatically shut off the compressor, use a closed chuck. Air will not be released until attached to the valve stem.

Part No. PA525 ・Closed Chuck / Standard
Part No. CH360 ・Closed Chuck / European Style

(Back to Top)

Our 25 ft. coilhose stows easily and is long enough to reach all four tires on most vehicles. The hose comes complete with a clip-on tire chuck and quick-disconnect coupler for easy attachment to your QuickAIR compressor or remote fitting.

ｼ" I.D. X 25 Ft.
185 PSI Rated

Part No. PA505 ・Hose with open chuck. For use with all compressor only applications.
Part No. PA505C ・Hose with closed chuck. For use with systems utilizing pressure switch protection only. Ideal for use with compressor-tank-install kit combos.

Note: Do not use a closed type chuck unless you have a pressure switch installed to turn off the compressor. Failure to do so will cause immediate excessive pressure buildup and may damage your compressor.

(Back to Top)

Installation Components

We also offer miscellaneous fittings. Contact a Sun Performance representative at sales@sunperformance.com for availability.
The picture to the right shows each part in the table below, in the same order of top to bottom / left to right. For pricing, see our Product & Pricing List.

(Back to Top)

Part # QA2P038 Brass Male Connector X ｼ" NPT Male	Part # PA520 40 Amp Relay	Part # PA523 Push-In Hose Tee X 3/8" OD Hose	Part # PA524 ｼ" NPT Female X 1/8" NPT Male Adapter
Part # PA513 Drain Cock X ｼ" NPT	Part # PA515 2" Quick Connect Coupler X ｼ" Female	Part # PA516 ｼ" NPT Internal Hex Plug	Part# PA517 ｼ" NPT Male Branch Tee	Part # PA518 Brass Male Connector X ｼ" NPT Female
Part # PA508 Reducer ・1/4" NPT to 1/8" NPT	Part # PA509 Push-In Hose Fitting 1/8" OD Hose X 1/8" NPT Male	Part # PA510 Push-In Hose Fitting 1/8" OD Hose X 1/8" NPT Female	Part # PA511 Push-In Hose Fitting 3/8" OD Hose X 1/4" NPT Male	Part # PA512 Push-In Hose Fitting 3/8" OD Hose X 1/4" NPT Female

Low Pressure Gauge

This Pencil-Type Pressure Gauge has a gold anodized finish with an easy to read, 4-sided nylon indicating bar and a handy pocket clip. The gauge also has a chuck guide to assure the gauge fits squarely on the tire valve. This prevents air leakage and guarantees accurate pressure readings.

Gold Anodized
0 - 20 psi range
Part # PG002

(Back to Top)